Value Collection 0896MPP 8-32x6in Pan Head Phillips Screw

Product Description

The VALUE COLLECTION 0896MPP is a pan head Phillips drive machine screw sized 8-32 with a 6-inch length under head. Manufactured from steel with a zinc finish, it meets ASME B18.6.3 and SAE J82 standards. The pan head profile provides a low-profile, broad bearing surface suited to general fastening applications in metal, plastic, and composite assemblies. The Phillips drive accepts standard Phillips bits and screwdrivers common on any job site. This screw is sold individually but carries a minimum order quantity of 10 units, making it appropriate for small-lot procurement in maintenance, repair, and fabrication work.

The 0896MPP is used wherever a steel machine screw with a pan head and Phillips drive is required. Typical applications include equipment panels, electrical enclosures, light fixtures, HVAC cabinet assembly, and general industrial or commercial maintenance. The inch-system thread sizing and standardized head geometry make it compatible with the widest range of tapped holes and pre-drilled components encountered in the field. It is installed by electricians, HVAC technicians, plumbers, and general maintenance trades.

Key Features

• 8-32 unified coarse thread for reliable engagement in standard tapped holes
• 6-inch length under head accommodates thicker material stacks or deep clearance applications
• Pan head profile provides broad clamping surface and low protrusion above the work surface
• Phillips drive compatible with standard Phillips No. 2 bits and screwdrivers
• Zinc finish provides basic corrosion resistance for indoor and protected environments
• Meets ASME B18.6.3 and SAE J82 fastener standards

Compatibility

Designed as a standard inch-series 8-32 machine screw compatible with any tapped hole or threaded insert conforming to 8-32 UNC thread specifications.

Installation Notes

Install using a Phillips No. 2 screwdriver or matching power-driver bit. Verify the mating hole is tapped to 8-32 UNC before driving to avoid cross-threading. Do not exceed the torque capacity of the zinc-finished steel; over-driving can strip the head drive recess or shear the fastener. When used in electrical enclosures, follow applicable NEC requirements for panel and enclosure fastening.