Value Collection 0880MPP Machine Screw 8-32 X 5 in Pan Head

Product Description

The VALUE COLLECTION 0880MPP is a pan head Phillips machine screw designed for general-purpose fastening applications in metal assemblies, electrical enclosures, and light mechanical equipment. Sized at 8-32 thread with a 5-inch length measured under the head, this fastener is manufactured from steel with a zinc plating finish that provides basic corrosion resistance. It conforms to ASME B18.6.3 and SAE J82 standards, confirming dimensional and material compliance for use where standardized fastener specs are required. Installation uses a standard Phillips driver and requires no washer. Sold individually with a minimum order quantity of 10 pieces.

This screw is suited for residential and commercial maintenance, panel assembly, electrical work, HVAC equipment mounting, and general mechanical fabrication where an 8-32 threaded fastener with 5-inch length is specified. The pan head profile seats flush against flat surfaces without requiring a countersink, making it appropriate for sheet metal, plastic housings, and light structural brackets. Licensed trades including electricians, HVAC technicians, and equipment installers commonly stock this size for field repairs and new installations.

Key Features

• 8-32 UNC thread for compatibility with standard tapped holes and nuts
• 5-inch length under head for deep-reach fastening applications
• Pan head profile provides a low-profile bearing surface without countersinking
• Phillips drive for use with common hand and power tools
• Zinc-plated steel finish for basic corrosion resistance in indoor environments
• Meets ASME B18.6.3 and SAE J82 dimensional and material standards

Compatibility

Designed as a standard 8-32 machine screw replacement for use in any application specifying an 8-32 x 5-inch pan head Phillips fastener per ASME B18.6.3.

Installation Notes

Install using a Phillips screwdriver or Phillips-tip power driver sized for a No. 2 bit. Ensure the mating hole is properly tapped to 8-32 threads before installation to avoid cross-threading or fastener damage. De-energize any electrical equipment fully before performing fastener work on live panels or enclosures. Do not exceed the material yield by over-torquing; tighten to snug plus firm hand-tool resistance unless a specific torque is called out by the equipment manufacturer.