Value Collection 07143 3/4-10 Unc Threaded Rod 3 Ft Grade B7

Product Description

The VALUE COLLECTION 07143 is a general-purpose threaded rod sized 3/4-10 UNC with a right-hand thread pattern and an overall length of 3 feet. Constructed from alloy steel to material grade B7, it delivers the high tensile strength and hardness required for demanding fastening and anchoring applications. A yellow zinc finish provides corrosion resistance for both indoor and moderate outdoor use. The rod weighs approximately 3.714 pounds and is a stock item for plumbers, pipefitters, electricians, HVAC technicians, and structural tradespeople who need reliable all-thread stock for hanging pipe, conduit, ductwork, and equipment.

This threaded rod is suited for residential and commercial mechanical, electrical, and plumbing installations where fully threaded fastening stock is required. Common applications include pipe hanger assemblies, beam clamp rigging, unistrut and channel framing systems, flange bolting, and general fixture mounting. The 3/4-10 UNC coarse thread pattern is compatible with standard hex nuts, coupling nuts, and pipe hanger hardware of the same thread specification. Grade B7 alloy steel makes it appropriate for elevated-temperature service environments such as boiler rooms and industrial HVAC mechanical rooms.

Key Features

• 3/4-10 UNC coarse right-hand thread for broad hardware compatibility
• Alloy steel construction to material grade B7 for high tensile and yield strength
• Yellow zinc finish for corrosion resistance in typical mechanical room environments
• 3-foot overall length provides workable stock for cut-to-length field use
• General-purpose designation suits a wide range of hanging, anchoring, and structural fastening tasks

Compatibility

Designed for use with standard 3/4-10 UNC hex nuts, coupling nuts, washers, and pipe hanger hardware. Suitable as general-purpose all-thread stock in mechanical, electrical, and plumbing support assemblies.

Installation Notes

Installation is typically performed by licensed plumbers, pipefitters, electricians, or HVAC mechanics following applicable building and mechanical codes. Cut to required length using a cold saw or abrasive cutoff tool, and re-chase the cut end with a die before threading on hardware. Always wear appropriate PPE when cutting. Verify that selected nuts and couplings match the 3/4-10 UNC thread specification before assembly to avoid cross-threading or fastener failure under load.