Value Collection 06811400 Compression Spring 0.36 in Od

Product Description

The VALUE COLLECTION 06811400 is a compression spring designed for general mechanical and industrial applications. It features a 0.36 inch outside diameter and a 1.75 inch free length, with a wire diameter of 0.041 inches. The spring delivers a rated spring rate of 9.09 pounds per inch and supports a maximum work load of 8.99 pounds. Sold in packs of 10, this spring suits applications where consistent, repeatable compression force is required. Installation is handled by mechanical assemblers, maintenance technicians, and light industrial trades working with equipment that uses small-diameter return or retention springs.

This compression spring fits applications calling for a compact, small-diameter coil spring in mechanical assemblies, tooling fixtures, valve mechanisms, or general equipment maintenance. The 0.36 inch outside diameter is suited for use in holes up to 0.375 inches in diameter, allowing close-fit installation. The 0.645 inch solid height leaves working travel room within typical spring pockets. This spring is appropriate for both original equipment builds and service replacement scenarios across light mechanical and industrial equipment.

Key Features

• 0.36 inch outside diameter sized for use in 0.375 inch diameter holes
• 1.75 inch free length with a 0.645 inch solid height for defined travel range
• 9.09 pounds per inch spring rate for predictable, linear compression response
• 8.99 pound maximum work load rating
• 0.041 inch wire diameter construction
• Sold in a pack of 10 for service stock or batch assembly use

Compatibility

Designed as an OEM-style replacement or service stock compression spring for general mechanical assemblies requiring a 0.36 inch OD coil spring with a 1.75 inch free length.

Installation Notes

Installation is performed by mechanical technicians or maintenance personnel using standard hand tools. Ensure the mating bore or spring pocket diameter does not exceed 0.375 inches for proper fitment and alignment. Relieve any stored energy in existing spring assemblies before removal. Verify free length and spring rate match the original specification before installing into load-bearing or safety-critical assemblies.