Value Collection 06810899 Compression Spring 0.3in Od

Product Description

The VALUE COLLECTION 06810899 is a small-diameter compression spring designed for light-duty mechanical applications requiring precise load control over a short travel range. With an outside diameter of 0.3 inches and a free length of 1.25 inches, this spring delivers a spring rate of 3.51 pounds per inch and a maximum work load of 3 pounds. Wire diameter measures 0.026 inches. The compact form factor and defined load characteristics make this spring suitable for instrument assemblies, valves, latches, and similar mechanisms where consistent return force is critical. Mechanical technicians and OEM assemblers are the typical installers.

This compression spring fits applications where a 0.3-inch outside diameter and a maximum hole diameter of 0.313 inches are specified. It is well-suited for light mechanical assemblies in HVAC controls, pneumatic valve return mechanisms, general industrial equipment, and precision instruments. With a solid height of 0.288 inches, the spring provides predictable deflection within its working range. It is sold in a package of 10, making it practical for bench stock and service kits.

Key Features

• Outside diameter of 0.3 inches fits holes up to 0.313 inches
• Free length of 1.25 inches with a solid height of 0.288 inches
• Spring rate of 3.51 pounds per inch for consistent, predictable deflection
• Maximum work load of 3 pounds suits light-duty return and latch applications
• Fine wire diameter of 0.026 inches allows compact coil packaging
• Packaged in quantities of 10 for bench stock and service use

Compatibility

Designed as a standard compression spring replacement or new installation component for light-duty mechanical assemblies requiring a 0.3-inch OD and 1.25-inch free length specification.

Installation Notes

Compression springs of this size are typically installed by mechanical technicians or assemblers during equipment maintenance or OEM assembly. Ensure the mating bore or housing diameter is within the specified hole diameter of 0.313 inches to maintain proper alignment and prevent side loading. Verify the installed load does not exceed the 3-pound maximum work load to avoid permanent set. De-energize or depressurize any system before replacing internal spring components.