Value Collection 02L20240 Galvanized Pipe Nipple 2in 24in Sch 40

Product Description

The VALUE COLLECTION 02L20240 is a galvanized steel pipe nipple used to connect sections of pipe in water supply, drainage, and general-purpose piping systems. Sized at 2 inches nominal diameter and 24 inches in length, it is manufactured to Schedule 40 wall thickness for reliable pressure handling in standard commercial and residential applications. Both ends are threaded for direct connection to fittings, couplings, or valves without additional preparation. Plumbers and pipefitters install this nipple in new construction and retrofit jobs where a close, reliable threaded connection is required.

This nipple is suited for residential and light commercial plumbing, fire protection rough-in, and industrial fluid transfer lines where galvanized steel is appropriate. The 24-inch length makes it a practical choice for spanning longer runs between fittings without adding a coupling. Schedule 40 wall thickness keeps the part within standard pressure ratings for cold and hot water service. Licensed plumbers, pipefitters, and maintenance technicians are the typical installers.

Key Features

• 2-inch nominal pipe size with Schedule 40 wall thickness for standard pressure service
• 24-inch length spans longer fitting-to-fitting distances without a coupling
• Galvanized steel construction provides corrosion resistance in wet or humid environments
• Threaded on both ends for direct connection to NPT fittings, couplings, and valves
• Weighs approximately 12.17 pounds

Compatibility

Designed as a standard replacement or new-installation nipple for 2-inch NPT threaded piping systems using Schedule 40 galvanized steel pipe components.

Installation Notes

Installation should be performed by a licensed plumber or qualified pipefitter in accordance with the International Plumbing Code (IPC) and applicable local codes. Shut off water supply and relieve system pressure before removing or installing any threaded pipe component. Apply an approved thread sealant or PTFE tape to all male threads before assembly. Do not over-tighten threaded connections, as this can crack fittings or damage threads.