Value Collection 0283437 Viton Round Cord Stock

Product Description

The VALUE COLLECTION 0283437 is a Viton round cord stock supplied in a 100-foot standard coil. Viton is a fluoroelastomer material widely used in sealing applications where resistance to oils, fuels, hydraulic fluids, and elevated temperatures is required. The cord measures 7/16 inch (0.4370 inches) in diameter and is suitable for cutting to custom gasket lengths, O-ring cord splicing, or use as a compression seal in grooves and channels. Maintenance technicians and mechanical contractors working on fluid-handling equipment, valves, pumps, and HVAC components commonly use this type of cord stock to fabricate or replace seals on-site.

This cord stock is suited for industrial and commercial maintenance environments where standard O-ring sizes are unavailable or a custom-length seal is needed. Typical applications include sealing flanged connections, valve stems, and hydraulic or pneumatic cylinder grooves. The 100-foot coil provides enough material for multiple fabricated seals from a single length. It is appropriate for use in both high-temperature and chemically aggressive service environments where standard rubber cord would degrade.

Key Features

• Viton fluoroelastomer construction provides resistance to oils, fuels, and high-temperature service
• Round cross-section, 7/16 inch (0.4370 inches) diameter for consistent seating in standard cord grooves
• 100-foot coil length allows on-site cutting to any required seal length
• Inch measurement system for straightforward sizing with standard tooling
• Single-piece coil packaging keeps cord protected and tangle-free until use

Compatibility

Designed as a general-purpose Viton round cord stock for fabricating custom seals and gaskets in fluid-handling, HVAC, and industrial equipment applications where a 7/16 inch diameter fluoroelastomer cord is specified.

Installation Notes

Seal fabrication from cord stock is typically performed by maintenance mechanics or licensed trade technicians. Depressurize and isolate the system before removing existing seals or disassembling any connection. Cut cord to the required length using a sharp, clean blade for a flush joint, and splice ends with an appropriate Viton-compatible adhesive if a closed-loop seal is needed. Follow equipment manufacturer specifications for groove dimensions and compression fit requirements.