Value Collection 0282275 Epdm Round Cord Stock 1/4 in 100 Ft

Product Description

The VALUE COLLECTION 0282275 is an EPDM round cord stock supplied in a 100-foot standard coil. EPDM (ethylene propylene diene monomer) rubber is widely used in sealing, gasketing, and weatherstripping applications where resistance to heat, ozone, UV exposure, and weathering is required. The cord measures 0.275 inches in diameter, commonly referenced as a 1/4-inch nominal size. Measurements follow the inch system of measurement. This cord stock is used by HVAC technicians, plumbers, and mechanical contractors who cut custom-length seals, gaskets, and compression seals in the field or shop.

EPDM round cord stock is suited for residential and commercial mechanical systems where a flexible, compressible sealing material is needed. Typical applications include door and access panel seals on HVAC equipment, pipe and fitting gaskets in plumbing systems, and general-purpose sealing in light industrial environments. The 100-foot coil length provides enough material for multiple cuts on a single job or across several service calls. This product is sold per coil with a minimum order quantity of 25 coils.

Key Features

• EPDM rubber construction provides resistance to heat, ozone, and outdoor weathering
• Round cross-section for consistent compression and sealing in grooves or channels
• 0.275-inch diameter (1/4-inch nominal) fits standard cord grooves in HVAC and mechanical equipment
• 100-foot coil allows field cutting to custom lengths without waste
• Inch measurement system for straightforward sizing in North American trade applications

Compatibility

Designed as a general-purpose EPDM round cord stock for use in HVAC, plumbing, and mechanical sealing applications where a 1/4-inch nominal diameter round cord is specified.

Installation Notes

Installation is typically performed by HVAC technicians, plumbers, or millwrights as part of equipment sealing or gasket fabrication. Power down and de-energize any equipment before replacing seals or gaskets. Cut cord to the required length using a sharp utility knife for a clean, square end. Ensure sealing grooves or channels are clean and free of old material before seating the new cord.