Value Collection 02106000 Galvanized Duct Tee Cover 6 Inch

Product Description

The VALUE COLLECTION 02106000 is a galvanized steel duct tee cover with crimp, designed for use in sheet metal ductwork systems. The crimp end allows the fitting to slide into adjacent duct sections for a secure, low-profile connection without additional hardware. At 6 inches inside diameter, this tee cover is sized for standard residential and light commercial HVAC trunk-and-branch duct configurations. HVAC installers and sheet metal workers use this fitting when extending or branching supply air distribution runs. The galvanized steel construction resists corrosion in typical indoor duct environments. The part ships as a single unit and weighs 0.4 pounds.

This tee cover is suited for forced-air HVAC duct systems where a branch takeoff is needed from a main trunk line. It is commonly installed in residential new construction and retrofit applications, as well as light commercial ventilation runs. The 6-inch inside diameter matches standard round duct pipe and flex duct collars used throughout residential supply systems. HVAC technicians and sheet metal contractors install this fitting during duct fabrication or repair when a tee branch point is required.

Key Features

• 6-inch inside diameter fits standard round duct and flex duct collars
• Crimp end allows direct insertion into adjoining duct sections for a snug fit
• Galvanized steel construction provides corrosion resistance in indoor duct environments
• Tee cover design creates a clean branch takeoff point in supply or return air distribution runs
• Lightweight at 0.4 pounds for easy handling during installation

Compatibility

Designed as an OEM-style replacement and standard-use fitting for 6-inch round galvanized ductwork systems in residential and light commercial forced-air HVAC applications.

Installation Notes

Installation is typically performed by a licensed HVAC technician or qualified sheet metal worker. Power down the air handling unit at the disconnect before working on any duct section. The crimp end should be inserted in the direction of airflow and secured with sheet metal screws and foil-backed tape per local mechanical code requirements. Do not use this fitting on systems outside its rated duct diameter.