Value Collection 01507010 Galvanized Duct Drawband 7 in Id

Product Description

The VALUE COLLECTION 01507010 is a galvanized steel duct drawband designed to secure round sheet metal ductwork connections in HVAC and ventilation systems. The drawband clamps over duct joints or collar connections, providing a tight mechanical hold that resists vibration and air pressure. With a 7 inch inside diameter and a 7 inch overall length, this standard gauge fitting is sized for use on 7 inch round duct runs. HVAC technicians and sheet metal installers use drawbands like this one as a fast, reliable alternative to sheet metal screws alone when securing flex duct to rigid collars or joining duct sections.

This drawband is suited for residential and light commercial HVAC ductwork installations wherever 7 inch round duct is used. Typical applications include supply and return air branch runs, trunk-to-branch collar connections, and transitions between rigid duct and flexible duct. It is commonly installed during new construction rough-in, duct replacement, or repair work on forced-air heating and cooling systems. The galvanized steel construction holds up in attic, crawlspace, and basement environments where moisture and temperature swings are routine.

Key Features

• 7 inch inside diameter fits standard 7 inch round duct
• 7 inch overall length provides substantial clamping surface along the duct joint
• Galvanized steel construction resists corrosion in unconditioned spaces
• Standard gauge material delivers consistent holding strength at duct connections
• Lightweight at 0.6 pounds for easy single-hand positioning during install

Compatibility

Designed as an OEM-style replacement and standard fitment drawband for 7 inch round galvanized ductwork systems in residential and light commercial forced-air HVAC applications.

Installation Notes

Installation is typically performed by a licensed HVAC technician or sheet metal worker. Power down the air handling unit and verify the system is depressurized before working on duct connections. Slide the drawband over the duct end before inserting it into the collar, then position and tighten once the duct is fully seated. Follow local mechanical codes and SMACNA duct construction standards for fastener requirements at supply and return connections.