Value Collection 0110090 Black Steel Pipe Nipple 1x9 Sch 40

Product Description

The VALUE COLLECTION 0110090 is a black steel pipe nipple designed for threaded pipe assemblies in plumbing, HVAC, gas distribution, and industrial piping systems. Manufactured from welded steel to Schedule 40 wall thickness, this nipple measures 1 inch in diameter and 9 inches in length. The black iron finish is standard for gas-line and steam applications where galvanized coatings are not required or permitted. Licensed plumbers and pipefitters install this component to extend or connect threaded pipe runs in both residential and commercial settings.

This nipple is suited for use in low-pressure gas piping, steam heating systems, water distribution, and general industrial fluid conveyance where Schedule 40 steel is specified. Its 1-inch nominal pipe size fits standard NPT fittings and valves across a broad range of applications. The 9-inch length is a common closet or extension nipple size used when a short threaded run is needed between fittings, valves, or equipment connections.

Key Features

• Schedule 40 wall thickness for standard-service pressure ratings in threaded steel pipe systems
• Welded steel construction provides consistent wall integrity along the full 9-inch length
• Black finish suitable for gas, steam, and non-potable water piping where uncoated steel is specified
• 1-inch nominal pipe size with standard NPT threads on both ends
• 9-inch length accommodates extension runs and equipment tie-ins requiring more clearance than close or short nipples

Compatibility

Designed as an OEM-style replacement and standard-service nipple for 1-inch NPT threaded pipe systems using Schedule 40 steel fittings, valves, and couplings.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local codes, the International Fuel Gas Code (IFGC), or the International Plumbing Code (IPC) depending on the service. Shut off and depressurize the system fully before removing or installing any threaded pipe component. Apply an approved thread sealant or PTFE tape rated for the intended service medium before making up the joint. Avoid over-tightening, which can crack fittings or distort threads.