Usa Industrials BULK-RS-NUS60-255 Neoprene Sheet Roll

Product Description

The USA INDUSTRIALS BULK-RS-NUS60-255 is a black neoprene rubber sheet roll designed for gasketing, sealing, padding, and vibration-dampening applications across HVAC, plumbing, industrial, and mechanical trades. The roll measures 1/8 inch thick and 36 inches wide with a plain backing, making it easy to cut to length on the job. Durometer hardness runs 50 to 60 Shore A, giving the material a firm yet compressible feel suited to moderate-duty sealing tasks. Tensile strength is rated at 2,500 psi, and the material holds up from -40 degrees F to 225 degrees F, covering a broad range of operating environments.

This sheet roll is used in both residential and light commercial settings wherever a field-cut rubber gasket, pipe wrap, equipment pad, or custom seal is needed. HVAC technicians use neoprene sheet stock to fabricate duct isolation pads and compressor mounts. Plumbers cut strips for flange gaskets and pipe support liners. Industrial maintenance crews use it for vibration isolation under pumps, fans, and mechanical equipment. The plain backing allows direct bonding with contact cement or double-sided tape.

Key Features

• 1/8 inch thickness with plain backing for straightforward field fabrication
• 36 inch width accommodates wide gaskets and pads without splicing
• Shore A durometer of 50 to 60 provides firm, moderate-duty compression sealing
• 2,500 psi tensile strength resists tearing during cutting and installation
• Temperature range of -40 degrees F to 225 degrees F suits most HVAC and plumbing service conditions
• Black neoprene construction offers good resistance to weathering, ozone, and moderate oil exposure

Compatibility

Designed as a general-purpose neoprene sheet stock suitable for field-fabricated gaskets, pads, and seals in HVAC, plumbing, and industrial mechanical applications.

Installation Notes

Cut with a sharp utility knife, tin snips, or die-cutting tools against a firm straight edge for clean edges. Degrease mating surfaces before applying contact adhesive if bonding is required. Installers should follow applicable mechanical and plumbing codes when using field-cut gaskets in pressurized or regulated systems. Verify chemical compatibility with the specific media the gasket will contact before installation.