Usa Industrials BULK-RS-NNFR70-14 Neoprene Sheet Roll 56in

Product Description

The USA INDUSTRIALS BULK-RS-NNFR70-14 is a nylon-reinforced neoprene rubber sheet roll supplied in a cut-to-length format, 56 inches wide, in black. The nylon reinforcement layer adds dimensional stability and tear resistance compared to unreinforced neoprene sheet stock. With a Shore A durometer rating of 65 to 75, this material sits in the medium-firm hardness range, suitable for gasket fabrication, sealing surfaces, vibration isolation pads, and protective liners. It carries a tensile strength of 1,100 psi and performs across a temperature range of -40 degrees F to 220 degrees F. Fabricators, maintenance technicians, and mechanical contractors are the primary users of this stock material.

This sheet roll is suited for industrial, commercial, and mechanical applications where oil-resistant, weather-resistant, and moderate-chemical-resistant elastomer sheet stock is required. Common uses include custom-cut gaskets for HVAC equipment, pump flanges, valve seats, and pipe connections. The cut-to-length format allows procurement of exact quantities needed for a job, reducing waste. The 56-inch width accommodates wide-format cutting for large gaskets or blanket liners without seams.

Key Features

• Nylon reinforcement provides added tear resistance and dimensional stability during cutting and installation
• Shore A durometer of 65 to 75 delivers a firm, resilient sealing surface suitable for moderate-pressure applications
• Tensile strength of 1,100 psi supports demanding mechanical sealing environments
• Operating temperature range of -40 degrees F to 220 degrees F covers most HVAC and mechanical service conditions
• Cut-to-length format allows precise material quantities without overstock
• 56-inch width enables wide single-piece cuts for large gaskets or liner panels

Compatibility

Designed as a general-purpose nylon-reinforced neoprene sheet stock for custom gasket cutting, sealing, and vibration isolation across industrial and mechanical trade applications.

Installation Notes

Cutting should be performed with a sharp utility knife, die cutter, or water-jet equipment on a flat, stable surface to ensure clean, accurate edges. Power down and depressurize any system before removing old gaskets or sealing material and installing new sheet-cut replacements. Follow applicable mechanical codes and equipment manufacturer torque sequences when reassembling flanged connections. Avoid prolonged contact with strong oxidizing acids or aromatic solvents, which can degrade neoprene compounds over time.