Usa Industrials BULK-RS-N40TXT-39 Neoprene Rubber Roll

Product Description

The USA INDUSTRIALS BULK-RS-N40TXT-39 is a cut-to-length neoprene rubber roll designed for gasketing, sealing, vibration dampening, and surface protection in trade and industrial applications. The roll is 36 inches wide and 0.093 inches thick, with a Shore A durometer rating of 40, placing it in the soft-to-medium flexibility range. A pressure-sensitive adhesive backing is factory-applied, allowing fast, tool-free bonding to metal, wood, and most rigid substrates. A textured surface finish improves grip and helps the material conform to uneven mating surfaces. This material is handled and installed by HVAC technicians, plumbers, pipefitters, and general maintenance professionals.

This neoprene roll is suited for residential and light commercial applications where a flexible, weather-resistant gasket or liner material is needed. Common uses include duct sealing, pipe insulation backing, equipment vibration isolation pads, and custom-cut gaskets for flanged connections. The cut-to-length format allows the installer to size pieces precisely on the job without waste. The black color is standard for neoprene and is UV-stable for short-term exterior exposure. Minimum service temperature is -20 degrees F and maximum is 170 degrees F, covering the range typical of HVAC and plumbing mechanical room environments.

Key Features

• Shore A 40 durometer - soft, conformable, and compressible for reliable sealing contact
• 0.093 inches thick with 36-inch roll width for large-format cutting flexibility
• Factory-applied adhesive backing for fast, clean installation on rigid surfaces
• Textured finish improves surface grip and mating-surface conformance
• Rated from -20 degrees F to 170 degrees F for broad HVAC and plumbing service range
• 1000 psi tensile strength provides durability under moderate compressive load

Compatibility

Designed as a general-purpose neoprene gasketing and sealing material for HVAC, plumbing, and mechanical insulation applications requiring a cut-to-length soft rubber sheet with adhesive backing.

Installation Notes

Cut to the required size using a sharp utility knife, straight edge, and cutting mat before removing the adhesive liner. Ensure the mating surface is clean, dry, and free of oil or dust before bonding, as contamination will reduce adhesive hold. For flanged or bolted connections, consult applicable torque guidance from the equipment manufacturer rather than relying on adhesive alone to maintain the seal. This material does not require special trade licensing to install, but work involving sealed HVAC or pressure piping systems should be performed by a licensed technician per local code.