Usa Industrials BULK-RS-BHS70-243 Buna-n Sheet Roll

Product Description

The USA INDUSTRIALS BULK-RS-BHS70-243 is a stock-length Buna-N rubber sheet roll used for gasket fabrication, sealing, vibration dampening, and surface protection in industrial and mechanical service applications. Buna-N (nitrile) compound provides solid resistance to oils, fuels, and many common industrial fluids. The roll measures 1 inch thick and 36 inches wide with a Shore A durometer rating of 65 to 75, placing it in the medium-firm hardness range. Tensile strength is rated at 1,500 psi. Weighing approximately 19.68 pounds, this roll is stocked in black and suited for job-site or shop cutting to custom shapes and sizes.

This sheet roll is used across maintenance, repair, and fabrication environments where a cut-to-size elastomer material is needed. Typical applications include custom gaskets, seals, wear pads, and anti-vibration mounts in plumbing, HVAC, industrial piping, and general mechanical systems. The material handles a service temperature range of -40 degrees F to 212 degrees F, making it viable for both cold-environment and moderate-heat applications. Plumbers, pipefitters, millwrights, and maintenance technicians are the primary end users.

Key Features

• Buna-N (nitrile) compound with good resistance to oils, fuels, and many industrial fluids
• Shore A durometer of 65 to 75 for medium-firm cut-and-seal applications
• 1,500 psi tensile strength for durable gasket and sealing performance
• Wide service temperature range: -40 degrees F to 212 degrees F
• 36-inch width allows large-format cutting without splicing
• Stock-length roll format ready for shop or field cutting

Compatibility

Designed as a general-purpose Buna-N elastomer sheet suitable for fabricating gaskets, seals, and pads in plumbing, HVAC, and industrial mechanical systems where nitrile rubber is specified.

Installation Notes

Cutting should be performed with a sharp utility knife, die cutter, or gasket punch set on a stable flat surface. Verify the finished gasket dimensions against the mating flange or surface before installation. Ensure all mating surfaces are clean and free of old gasket material prior to fitting. Follow applicable system pressure and fluid compatibility requirements before placing cut parts into service.