Usa Industrials BULK-RS-BHS60-240 Buna-n Sheet Roll

Product Description

The USA INDUSTRIALS BULK-RS-BHS60-240 is a black Buna-N (nitrile) rubber sheet roll used for gasketing, sealing, vibration dampening, and general-purpose padding in industrial and mechanical applications. The sheet measures 3/8 inches thick and 36 inches wide, with a Shore A durometer rating of 50 to 60, placing it in the medium-soft range. Tensile strength is rated at 1500 psi. The temperature range spans -40 degrees F to 212 degrees F, making it suitable for environments with moderate heat exposure or cold-weather service. Plumbers, pipefitters, millwrights, and maintenance technicians commonly work with this material.

Buna-N rubber is widely used in applications where oil, fuel, and water resistance are required. This sheet roll format is suited for job-site or shop fabrication of custom gaskets, seals, liners, and wear pads. Typical uses include flange gaskets, equipment mounts, tank liners, and cut-to-fit seals in plumbing, HVAC, and light industrial equipment. The black color and stock-length format allow straightforward cutting to size with standard utility or die-cutting tools.

Key Features

• Buna-N (nitrile) rubber construction provides resistance to oils, fuels, and water-based fluids
• Shore A durometer of 50 to 60 for medium-soft flexibility and compressibility
• Tensile strength of 1500 psi for reliable performance under compression and load
• Operating range of -40 degrees F to 212 degrees F suits a wide range of service environments
• 36-inch width and sheet roll format allow custom cutting to fit specific gasket or seal dimensions
• 3/8 inch thickness accommodates standard flange and gasketing applications

Compatibility

Designed as a general-purpose Buna-N rubber sheeting material for fabrication of gaskets, seals, pads, and liners across plumbing, HVAC, and industrial maintenance applications.

Installation Notes

Cut to size using a sharp utility knife, straight edge, or die-cutting press on a stable, flat surface. Ensure the mating surfaces are clean and free of debris before installing any fabricated gasket or seal. Verify chemical compatibility with the specific fluids or gases present in the system before installation. Follow applicable industry codes and equipment manufacturer guidelines for gasket material selection and torque procedures.