Usa Industrials BULK-PS-PTFE-267 Virgin Ptfe Bar 0.25x4x48 in

Product Description

The USA INDUSTRIALS BULK-PS-PTFE-267 is a rectangular virgin PTFE (polytetrafluoroethylene) plastic bar stock used as a raw material for machined seals, gaskets, bushings, liners, and custom fabricated components. Virgin-grade PTFE delivers the full chemical resistance, low friction coefficient, and non-stick properties inherent to the material without regrind or filler content. The bar measures 0.25 inches thick, 4 inches wide, and 48 inches long, weighing approximately 3 pounds. It is cut and machined by fabricators, mechanical contractors, and industrial maintenance technicians to produce parts for fluid handling, chemical processing, and mechanical assemblies.

This bar stock is suited for applications requiring broad chemical resistance, high-temperature tolerance, and electrical insulation in a machinable flat profile. Common uses include fabricating custom gaskets, slide pads, valve seats, bearing pads, and insulating components in plumbing, HVAC, chemical, and industrial plant environments. The rectangular profile allows efficient use on mills, lathes, band saws, and CNC equipment. The white color is standard for virgin-grade unfilled PTFE stock.

Key Features

• Virgin PTFE material with no regrind or fillers for maximum chemical resistance
• Rectangular bar profile: 0.25 inches thick by 4 inches wide by 48 inches long
• Dimensional tolerance of plus or minus 0.060 inches on thickness
• White color standard for unfilled virgin PTFE bar stock
• Machinable on standard metalworking and woodworking equipment
• Suitable for high-temperature and chemically aggressive service environments

Compatibility

Designed as general-purpose virgin PTFE bar stock for machining and fabrication into seals, gaskets, liners, and structural insulating components across plumbing, HVAC, chemical processing, and industrial maintenance applications.

Installation Notes

This is raw bar stock intended for shop fabrication, not direct installation. Cutting, milling, and drilling should be performed with sharp tooling at low feed rates to prevent deformation of the material. Finished parts machined from this bar should be installed by qualified tradespeople following applicable mechanical and piping codes for the specific end-use application. Wear appropriate respiratory protection when machining PTFE, as fine particulate dust requires ventilation or a suitable respirator.