Tru-maxx 88564 Wheel Brush 2 in Crimped Carbon Steel

Product Description

The TRU-MAXX 88564 is a shank-mount wheel brush designed for deburring, cleaning, and surface prep on metal, welds, and hard-to-reach surfaces. The brush features a 2-inch outside diameter with a crimped carbon steel fill and mounts via a 1/4-inch shank for use in standard rotary tools, die grinders, and drill presses. At a rated speed of 20,000 RPM, it handles aggressive cleaning and finishing passes without bogging down. The crimped wire construction provides flexibility and consistent contact across irregular surfaces. Weighing 0.1 pounds, this is a lightweight, single-piece tool ready for immediate use.

This wheel brush is suited for metalworking shops, fabrication environments, and maintenance applications where a compact rotary brush is needed. Typical tasks include rust removal, paint stripping, scale cleaning, and weld seam preparation on pipe, tubing, castings, and plate stock. The 3/8-inch face width and 7/16-inch trim length make it effective in grooves and tight contours where larger brushes cannot reach. It is commonly used by machinists, pipefitters, welders, and general maintenance technicians.

Key Features

• 2-inch outside diameter for compact rotary brush applications
• Crimped carbon steel fill for flexible, consistent surface contact
• 1/4-inch shank included for direct chuck or collet mounting
• Rated to 20,000 RPM for use with die grinders and rotary tools
• 3/8-inch face width and 7/16-inch trim length for work in tight spaces
• Lightweight at 0.1 pounds for extended handheld use

Compatibility

Designed for use with die grinders, drill presses, and rotary tools equipped with a 1/4-inch chuck or collet. Verify that the tool speed rating meets or exceeds the rated RPM of the brush before use.

Installation Notes

A licensed or qualified technician should confirm that the rotary tool is rated at or above the maximum brush RPM before mounting. Always power down and disconnect the tool from its power source before installing or removing the brush. Secure the shank fully in the chuck or collet and confirm there is no wobble before operating. Wear appropriate eye protection and follow applicable ANSI safety standards for abrasive and wire brush operation.