Tru-maxx 66253292125 Mounted Point W237 60 Grit

Product Description

The TRU-MAXX 66253292125 is a cylinder-shaped aluminum oxide mounted point designed for grinding, deburring, and surface blending on metal and other hard materials. The W237 point shape features a 1 inch head thickness and mounts on a 1/4 inch diameter shank that is 1.5 inches long. At 60 grit with a medium grade, it removes material efficiently while leaving a consistent finish. Rated at 22,500 RPM maximum, it is compatible with most die grinders and rotary tools. Machinists, tool and die makers, and maintenance technicians use this type of mounted point for precision work in confined areas where larger abrasive wheels cannot reach.

This mounted point is suited for internal grinding, weld cleanup, mold finishing, and deburring operations on steel, cast iron, and similar metals. The aluminum oxide abrasive is a general-purpose material that performs well on ferrous metals and hard alloys. The cylinder W237 shape allows flat-faced contact on internal bores, slots, and flat surfaces. It is commonly used in job shops, fabrication facilities, and maintenance environments where die grinders are standard equipment.

Key Features

• W237 cylinder point shape for flat-face contact on bores and flat surfaces
• 60 grit medium grade for efficient material removal with controlled finish
• Aluminum oxide abrasive construction suited for ferrous metals and hard alloys
• 22,500 RPM maximum speed rating compatible with most die grinders
• 1/4 inch shank diameter fits standard die grinder collets
• Lightweight at 0.02 pounds for reduced operator fatigue during extended use

Compatibility

Designed to fit die grinders and rotary tools accepting a 1/4 inch shank collet. Verify that the tool RPM rating meets or exceeds the 22,500 RPM maximum rating of this mounted point before use.

Installation Notes

Mounting and removal should be performed by a qualified machinist or maintenance technician with the die grinder fully powered off and disconnected from its air or electrical source. Inspect the mounted point for cracks or chips before each use and discard any damaged points immediately. Always confirm the tool spindle speed does not exceed the 22,500 RPM maximum rating marked on the point. Eye protection and appropriate PPE are required per ANSI B7.1 safety standards for abrasive wheel use.