Tripp Lite U330F-15M-G1 Usb 3.1 Gen 1 Active Optical Cable

Product Description

The TRIPP LITE U330F-15M-G1 is a 15-meter USB 3.1 Gen 1 Active Optical Cable (AOC) designed for long-distance USB signal extension without signal degradation. Active optical technology converts the electrical USB signal to fiber-optic light transmission and back, allowing reliable data transfer at USB 3.1 Gen 1 speeds over distances that exceed the limitations of standard passive copper cables. The CL3 in-wall rating makes this cable suitable for installation inside wall cavities and conduit runs in commercial and residential environments. Electricians and low-voltage installers are the primary trades working with this product.

This cable is suited for fixed installations where a USB 3.1 Gen 1 Type-A male to Type-A female connection is needed over an extended run — typically for AV systems, digital signage, kiosk builds, boardroom setups, or industrial workstation connections. The CL3 rating supports in-wall routing in accordance with NEC requirements for low-voltage wiring. At 15 meters, it addresses runs well beyond the 5-meter limit of passive USB 3.0 or 3.1 Gen 1 copper cables.

Key Features

• Active optical construction enables 15-meter USB 3.1 Gen 1 signal extension
• CL3 jacket rating permits in-wall installation per NEC guidelines
• USB 3.1 Gen 1 specification supports up to 5 Gbps data transfer rate
• Male Type-A to Female Type-A configuration for in-line extension use
• Eliminates signal loss associated with passive copper cables at extended distances

Compatibility

Designed for use with USB 3.1 Gen 1 and USB 3.0 Type-A host ports and peripherals requiring long-distance cable extension in fixed installation environments.

Installation Notes

Installation is typically performed by licensed electricians or low-voltage cabling technicians. When routing through walls, verify that the CL3 jacket rating meets local code requirements under NEC Article 800 or applicable low-voltage wiring provisions. Power down or disconnect the host device from the USB port before connecting or routing the cable. Do not exceed the minimum bend radius of the optical fiber assembly, as sharp bends can cause permanent signal loss in the optical core.