
Ships same day if ordered by 12 pm
Manufacturer pricing rules prevent us from advertising our discount — no account or email required to see it.
Secure Payments
Easy Returns
Expert Advice
Fast Shipping
The TRIM TO THE TRADE 4T-401N-1 is a chrome-plated pipe nipple sized at 1/2 inch IPS with a 2 inch length. Nipples are short threaded pipe fittings used to connect two female-threaded fittings or extend a threaded pipe run. This fitting is a standard component in residential and light commercial plumbing supply lines, fixture trim assemblies, and valve installations. Plumbers and pipefitters rely on IPS-threaded nipples when assembling or repairing supply connections at sinks, faucets, and similar fixtures. The chrome finish provides a clean appearance suitable for exposed installations.
This nipple is appropriate for use in potable water supply lines, drain and vent assemblies, and decorative plumbing trim applications where a 1/2 inch IPS thread pattern is required. It is commonly installed at fixture supply stops, angle valves, and escutcheon assemblies. The 2 inch body length makes it suitable for close-couple connections where a standard close nipple would be too short but a longer extension is unnecessary.
Designed as a standard replacement or new-installation nipple for 1/2 inch IPS threaded plumbing assemblies in residential and light commercial settings.
Shut off the water supply and relieve line pressure before removing or installing any threaded fitting. Apply thread sealant tape or pipe joint compound to male threads before assembly, following local plumbing code requirements. A pipe wrench or basin wrench is typically used to tighten threaded nipples to hand-tight plus appropriate turns. Installation should conform to applicable IPC or local plumbing code standards.
Thanks for subscribing!
This email has been registered!