Tingley V81622.S-M High Visibility Safety Vest Class 2

Product Description

The TINGLEY V81622.S-M is a high visibility safety vest designed for trade professionals working in environments with vehicle traffic, low-light conditions, or electrical hazards. Sized for Small/Medium with a chest fit range of 36 to 42 inches, this vest meets ANSI Class 2 requirements and carries NFPA 70E CAT 1 approval, making it appropriate for electricians and utility workers operating near energized equipment. The lime-colored vest features a single horizontal silver stripe measuring 2 inches wide for high-contrast visibility. Hook-and-loop closure provides a secure, adjustable fit without snaps or zippers.

This vest is suited for residential and commercial jobsites where ANSI Class 2 hi-vis PPE is required by site safety plans or OSHA regulations. Electricians, linemen, utility technicians, HVAC service techs, and general contractors use this vest when working near active roadways, in parking structures, or in arc-flash-rated environments. The flame-resistant construction makes it appropriate for compliance with NFPA 70E CAT 1 arc-flash PPE requirements. A D-ring access point accommodates fall protection harness pass-through, making it compatible with full-body harness systems.

Key Features

• ANSI Class 2 high visibility rating for jobsite and roadway compliance
• NFPA 70E CAT 1 flame-resistant construction for arc-flash environments
• D-ring access slot for fall protection harness compatibility
• 2-inch silver horizontal stripe for high-contrast identification
• Hook-and-loop front closure for easy on/off and adjustable fit
• Lightweight, no-pocket design reduces bulk during active work

Compatibility

Designed as an ANSI Class 2 hi-vis vest for Small/Medium users with a chest size of 36 to 42 inches, suitable for general PPE programs requiring NFPA 70E CAT 1 flame-resistant high visibility outerwear.

Installation Notes

This vest is donned as personal protective equipment and requires no tools or fasteners. Inspect the hook-and-loop closure and stripe reflectivity before each use for signs of wear or contamination that may reduce visibility or flame resistance. Follow your site safety plan and applicable OSHA 29 CFR 1926 or NFPA 70E guidelines for PPE selection and inspection intervals. Do not launder with fabric softener or bleach, as these can degrade flame-resistant properties.