Tigre Usa Inc 1402-010 Poly Fpt Insert Tee 1 Inch

Product Description

The TIGRE USA INC 1402-010 is a 1-inch Polyethylene Female Pipe Thread (FPT) Insert Tee designed for cold water distribution systems using PE polyethylene pipe. This fitting connects two pipe runs and adds a female-threaded branch outlet, allowing a threaded male fitting or valve to tie in at a perpendicular angle. The connection configuration is Plastic x Plastic x Female. Installation requires stainless steel clamps to secure the insert ends to the PE pipe. This fitting is rated for cold water service only and is listed under ASTM D-2609, NSF 14, and NSF 16 for potable water applications. It is typically installed by licensed plumbers working on underground or above-grade cold water supply lines.

The 1402-010 is intended for cold water polyethylene pipe systems in agricultural, irrigation, and light commercial or utility applications. It is not approved for use inside dwellings, and it must not be used with compressed air or any gas service. The NSF 14 and NSF 16 listings confirm suitability for potable water service where those certifications are required by local plumbing codes. Stainless steel insert clamps are required for a proper, leak-free connection and should be installed according to the clamp and pipe manufacturer guidelines.

Key Features

• FPT branch outlet allows direct connection of threaded male fittings or valves
• ASTM D-2609 listed for polyethylene pipe insert fittings
• NSF 14 and NSF 16 listed for potable cold water service
• Designed for use with stainless steel clamps on PE polyethylene pipe
• Cold water service only — not rated for compressed air, gas, or hot water
• Fitting modifications void the manufacturer warranty

Compatibility

Designed for use with PE polyethylene pipe secured with stainless steel clamps. Cold water service only. Not approved for installation inside a dwelling or for use with compressed air or gases.

Installation Notes

Installation of polyethylene insert fittings is typically performed by a licensed plumber. Shut off and depressurize the water supply line before cutting into the existing pipe. Slide stainless steel clamps onto the PE pipe before inserting the fitting, then position the clamps over the barbed ends and torque according to the clamp manufacturer specifications. Do not modify the fitting in any way, as doing so voids the warranty and may compromise the integrity of the joint.