Thomas Betts UA7AF Pvc Conduit Elbow 1 Inch Rigid

Product Description

The THOMAS BETTS UA7AF is a PVC conduit elbow designed for use with rigid conduit systems in non-hazardous electrical installations. This angled, insulated fitting uses a solvent-glued connection to form a secure, permanent joint. Made from polyvinylchloride, it resists moisture and corrosion, making it a reliable choice for both indoor and outdoor conduit runs where a directional change is required. Licensed electricians and electrical contractors install this type of fitting when routing rigid PVC conduit through walls, ceilings, and underground pathways. The 1-inch trade size accommodates standard rigid PVC conduit of that nominal diameter.

This elbow is suited for residential and commercial electrical conduit installations where non-hazardous area classification applies. It is used wherever a rigid PVC conduit run requires a change in direction. Typical applications include service entrances, panel feeds, underground conduit runs, and exposed interior raceways in dry or wet locations. The glued connection method makes it compatible with standard PVC conduit cement, which is the accepted installation practice for rigid PVC conduit fittings per NEC guidelines.

Key Features

• Angled elbow configuration for directional changes in rigid PVC conduit runs
• Solvent-glued connection provides a permanent, secure joint
• Polyvinylchloride construction resists moisture, corrosion, and many chemicals
• Insulated fitting suitable for non-hazardous area applications
• 1-inch trade size fits standard rigid PVC conduit of that nominal diameter

Compatibility

Designed as an OEM-style replacement fitting for 1-inch trade size rigid PVC conduit systems in non-hazardous electrical installations.

Installation Notes

Installation is performed by licensed electricians in accordance with the National Electrical Code (NEC). De-energize all circuits and confirm the conduit run is clear before fitting. Apply approved PVC solvent cement to both the conduit end and the fitting socket before joining, and allow adequate cure time before pulling wire. Do not use this fitting in classified hazardous locations.