Thomas Betts TYH28M Standard Cable Tie 14.2in Green Nylon

Product Description

The THOMAS BETTS TYH28M is a standard nylon cable tie designed for bundling and securing wire harnesses, conduit, and cable runs in electrical and low-voltage installations. Measuring 14.2 inches in overall length with a 4-inch maximum bundle diameter, it handles mid- to large-diameter bundles with a rated tensile strength of 50 lb. Manufactured from nylon and finished in green for color-coded identification, this tie is suited for use in panel builds, wire management trays, and general electrical rough-in work. Electricians, installers, and maintenance technicians use this tie where a reliable, color-keyed bundle solution is needed.

This cable tie is appropriate for residential and light commercial electrical work, structured cabling, data center cable management, and industrial wiring applications. The green color supports visual circuit or zone identification. With a rated operating range of -40 degrees F to 221 degrees F, the TYH28M performs in both indoor and moderate outdoor environments. It ships in a pack of 1000, making it practical for high-volume installations and service vehicles stocked for ongoing work.

Key Features

• 14.2-inch length accommodates a maximum bundle diameter of 4 inches
• 50 lb tensile strength for secure, long-term bundle retention
• Green nylon construction supports color-coded wire identification
• Rated from -40 degrees F to 221 degrees F for a wide range of environments
• RoHS compliant and UL Listed (File E49405), UL Recognized, CSA62275 Type 2, and EN certified
• Meets ASTM D4066 PA121 material standard

Compatibility

Designed as a standard-duty cable tie for general electrical, low-voltage, and industrial wiring applications where a 14.2-inch, 50 lb nylon tie with a 4-inch maximum bundle capacity is required.

Installation Notes

Cable ties are typically installed by electricians, low-voltage technicians, and panel builders using a manual pull or cable tie gun tool. Cinch ties firmly but avoid over-tensioning, which can damage insulation on delicate conductors. Trim the tail flush with the locking head after securing. Follow NEC bundling and fill requirements where applicable.