Thomas Betts TY24M-5 Standard Cable Tie 5.5in Green 1000pk

Product Description

The THOMAS BETTS TY24M-5 is a standard nylon cable tie designed for secure bundling of wire, cable, and hose assemblies in electrical, HVAC, and general trade applications. Measuring 5.5 inches in length with a 0.14-inch width and 0.041-inch thickness, this tie delivers a 40-pound tensile strength in a lightweight, green-colored form. The UV-resistant nylon construction holds up in outdoor and sun-exposed installations without becoming brittle. Electricians, HVAC technicians, and plumbers reach for this tie when routing and securing runs through panels, conduit supports, equipment cabinets, and mechanical rooms. Each order ships as a 1,000-piece package, suitable for job-site stock or contractor supply.

This cable tie fits standard bundling tasks in residential and light commercial settings. It accommodates a maximum bundle diameter of 1.38 inches, making it practical for small to mid-sized wire harnesses, conduit groups, and refrigerant line sets. The green color assists with color-coding and identification in multi-system installations. Operating temperature range spans from -40 degrees F to 221 degrees F, supporting use in both cold outdoor environments and warm equipment spaces such as furnace closets, rooftop units, and electrical rooms.

Key Features

• 40-pound tensile strength for reliable hold on wire and cable bundles
• UV-resistant nylon construction resists degradation in outdoor or sun-exposed locations
• 5.5-inch length accommodates bundle diameters up to 1.38 inches
• Operating range of -40 degrees F to 221 degrees F suits a wide variety of install environments
• Green color supports color-coding practices in multi-system wiring and piping runs
• Sold in a 1,000-piece package for efficient job-site and shop stocking

Compatibility

Designed as a standard-duty, one-piece nylon cable tie for general wire and cable bundling tasks across electrical, HVAC, plumbing, and mechanical trade applications.

Installation Notes

Cable ties of this type are installed by hand or with a tensioning tool; a flush-cut tool should be used to trim the tail close to the locking head to avoid sharp edges that can cut insulation or skin. Power down circuits before routing and securing wire bundles inside panels or equipment enclosures. Follow NEC guidelines when bundling current-carrying conductors, as grouping can affect ampacity derating requirements. Do not over-tighten ties on insulated conductors, as compression can damage jacket integrity over time.