Thomas Betts TY24M-3 Standard Cable Tie Orange Nylon

Product Description

The THOMAS BETTS TY24M-3 is a standard nylon cable tie designed for bundling and organizing wire and cable runs in electrical, HVAC, and general trade applications. At 5.5 inches in overall length with a 40-pound tensile strength, this tie handles light to moderate bundling loads reliably. The orange color aids in visual identification on the job site or in panel work. Constructed from UV-resistant nylon, the TY24M-3 is suitable for both indoor and outdoor installations where sun exposure is a factor. Rated for operation from -40 degrees F to 221 degrees F, it holds up across a wide range of service environments. This package contains 1000 ties.

The TY24M-3 is used by electricians, HVAC technicians, and other trade professionals for securing wire harnesses, low-voltage control wiring, and cable bundles in panels, conduit runs, mechanical rooms, and outdoor equipment installations. The orange color makes it a practical choice when color-coded bundling is needed to distinguish wire groups or circuit types. The UV-resistant material makes it appropriate for rooftop units, outdoor disconnects, and exposed conduit applications where standard nylon ties would degrade over time.

Key Features

• 40-pound tensile strength for reliable bundling of light to moderate cable loads
• UV-resistant nylon construction rated for outdoor and sun-exposed installations
• Operating temperature range of -40 degrees F to 221 degrees F
• Orange color supports color-coded cable identification and organization
• Maximum bundle diameter of 1.38 inches accommodates typical wire harness sizes
• CSA Certified and UL Listed

Compatibility

Designed as a standard-duty cable tie for general wire and cable bundling applications across electrical, HVAC, plumbing, and mechanical trades. Compatible with any installation requiring a 5.5-inch nylon tie with a maximum bundle diameter of 1.38 inches.

Installation Notes

Cable ties are installed by hand or with a cable tie tensioning tool to achieve consistent pull force and flush cut-off. De-energize circuits and follow applicable NEC guidelines before working inside electrical panels or control enclosures. Avoid over-tensioning ties on insulated conductors to prevent damage to wire insulation. Excess tail length should be trimmed flush with a cutting tool after securing.