Thomas Betts L-8-18-0-C Standard Cable Tie 8 in 100 Pack

Product Description

The THOMAS BETTS L-8-18-0-C is a standard-duty nylon cable tie designed for bundling and securing wire harnesses, conduit runs, and cable assemblies in electrical, HVAC, and general trade applications. Each tie measures 8 inches in overall length with an 18 lb tensile strength, providing reliable hold for light to moderate bundling tasks. The black nylon construction is UV-resistant and weather-resistant, making it suitable for both indoor panels and outdoor or exposed installations. Rated to a maximum operating temperature of 221 degrees F, these ties maintain integrity in warm environments common to electrical enclosures and rooftop equipment. Sold in a pack of 100.

These cable ties are used by electricians, HVAC technicians, and plumbing contractors wherever wire management and bundling are required. Typical applications include securing low-voltage control wiring, organizing line-voltage conductors inside panels, bundling refrigerant line insulation, and routing cables along equipment frames. The 2-inch maximum bundle diameter accommodates a range of standard wire bundle sizes encountered in residential and light commercial work. UV and weather resistance makes them a practical choice for outdoor-rated installations and rooftop units.

Key Features

• 8-inch overall length accommodates a wide range of bundling applications
• 18 lb tensile strength provides secure, reliable hold
• Black nylon construction is UV-resistant and weather-resistant
• Supports maximum bundle diameter of 2 inches
• Rated to 221 degrees F maximum operating temperature
• UL Recognized (File E4905) for use in listed assemblies
• Pack of 100 ties for job-site convenience

Compatibility

Designed as a standard-duty cable tie suitable for general wire bundling and management in electrical, HVAC, plumbing, and mechanical trade applications.

Installation Notes

Cable ties of this type are installed by electricians, HVAC technicians, and general contractors using standard cable tie tensioning tools or by hand. Always de-energize circuits before working inside electrical panels or control enclosures. Trim the tail flush after tensioning to avoid sharp edges that could damage adjacent wire insulation. Follow NEC guidelines for cable bundling and support spacing in electrical installations.