Thomas Betts L-7-50ID-9-C Standard Cable Tie 50 Lb

Product Description

The THOMAS BETTS L-7-50ID-9-C is a standard-duty nylon cable tie designed for bundling and securing wire harnesses, conduit runs, and cable assemblies in electrical, HVAC, and general trade installations. At 7.5 inches in overall length with a 50-pound tensile strength, it provides reliable hold across a wide range of bundling tasks. The natural (clear) nylon construction resists common shop chemicals and performs in environments up to 185 degrees F. This tie ships in a pack of 100, making it practical for stocking on service vans or at job sites where volume use is expected.

This cable tie is suited for residential and light commercial electrical work, HVAC panel wiring, low-voltage control wiring, and mechanical equipment installations. Electricians, HVAC technicians, and plumbers commonly use standard cable ties like this one to dress wire runs, secure tubing, and organize harnesses during rough-in or service work. The 1.75-inch maximum bundle diameter accommodates moderate-sized wire bundles typical in panel wiring and equipment connections.

Key Features

• 50-pound tensile strength for secure, long-term bundling
• 7.5-inch overall length handles bundles up to 1.75 inches in diameter
• Natural nylon material withstands temperatures up to 185 degrees F
• 0.187-inch strap width and 0.053-inch thickness for a low-profile, self-locking fit
• UL Recognized under File E4905
• Pack of 100 for job-site and van-stock efficiency

Compatibility

Designed as a standard OEM-style replacement or direct-use cable tie for electrical, HVAC, plumbing, and general mechanical bundling applications requiring a 7.5-inch, 50-pound natural nylon strap.

Installation Notes

Cable ties are installed by hand or with a standard cable tie tensioning and cut-off tool for consistent pull force and flush trimming. De-energize all circuits before dressing wire bundles inside panels or enclosures, following NEC requirements for the specific installation. Avoid overtightening around insulated conductors in a way that could damage jacket integrity. Cut tails flush to prevent sharp edges that can cause hand injuries during future service.