Thomas Betts L-14-50-0-C Cable Tie 14.1 in 50 Lb Black 100pk

Product Description

The THOMAS BETTS L-14-50-0-C is a standard nylon cable tie rated for 50 lb tensile strength and designed for organizing and bundling wire harnesses, conduit runs, and cable management applications. At 14.1 inches in overall length and 0.187 inches wide, it handles bundle diameters up to 4 inches. Molded from black UV-resistant nylon, the tie carries weather-resistant properties that make it suitable for both indoor and outdoor installations. It is sold in a package of 100 and is recognized under UL File E4905. Licensed electricians, HVAC technicians, and general contractors commonly stock this tie for panel work, equipment installations, and service calls.

This cable tie is appropriate for residential and commercial applications wherever wire management is required. Typical uses include bundling low-voltage control wiring, securing conduit to supports, organizing HVAC equipment wiring inside air handlers and rooftop units, and general electrical panel dress-out. The UV and weather resistance makes it a practical choice for exterior raceways, rooftop equipment curbs, and exposed outdoor wiring environments where standard ties would degrade under sunlight and moisture exposure.

Key Features

• 50 lb tensile strength for secure, long-term bundling of wire and cable
• 14.1 inches overall length accommodates bundle diameters up to 4 inches
• UV-resistant and weather-resistant nylon construction for outdoor and exposed applications
• Black color provides low visibility on dark conduit and wiring assemblies
• Maximum operating temperature of 221 degrees F for use near heat-generating equipment
• UL Recognized under File E4905 for compliance-sensitive installations
• Sold in a 100-piece package for job-site and service-van stocking

Compatibility

Designed as a standard-duty cable tie for general wire management across residential, commercial, and light industrial electrical, HVAC, and mechanical applications where a 14.1-inch, 50 lb rated tie with UV resistance is required.

Installation Notes

Cable ties are installed by electricians, HVAC technicians, and mechanical contractors as part of wire management and code-required bundling practices. Always de-energize circuits before dressing or re-routing wiring. Use a cable tie gun or flush-cut tool to tension and trim the tail cleanly without leaving a sharp edge that could damage insulation. NEC guidelines govern wire bundling practices in electrical panels and raceways and should be consulted for fill and ampacity derating requirements.