Thomas Betts ERG50 Cable Tie Installation Tool 18-50 Lb

Product Description

The THOMAS BETTS ERG50 is an automatic cable tie installation tool designed for fast, consistent tensioning and cutting of plastic cable ties in the field. Built from durable plastic construction, this tool accommodates nylon cable ties ranging from 0.094 inches to 0.184 inches in width and handles tensile strengths from 18 to 50 pounds. The automatic actuation mechanism tensions and cuts the tail in a single squeeze, reducing hand fatigue during repetitive tie-down work. Electricians, HVAC technicians, and panel wiring pros reach for this type of tool when securing wire bundles, conduit runs, and equipment harnesses in both residential and light commercial applications.

The ERG50 is suited for use on nylon cable ties in wire management tasks across electrical panels, HVAC equipment wiring, conduit bundles, and low-voltage control wiring installations. The tool's compatibility range of 0.094 to 0.184 inch tie widths covers the most common standard cable tie sizes used in trade work. Its lightweight plastic body makes it practical for overhead work or extended use on a job site without added strain.

Key Features

• Automatic actuation tensions and cuts the cable tie tail in one motion
• Compatible with nylon cable ties from 0.094 to 0.184 inches wide
• Handles cable ties rated 18 to 50 lb tensile strength
• Lightweight plastic tool body reduces hand fatigue during repetitive installs
• RoHS compliant construction

Compatibility

Designed for use with nylon cable ties ranging from 0.094 to 0.184 inches in width and rated between 18 and 50 lb tensile strength. Specific compatible tie series were not identified in the product data; verify tie width and tensile rating before use.

Installation Notes

This tool is typically used by licensed electricians, HVAC technicians, and low-voltage installers during panel wiring, equipment servicing, or conduit bundling work. Always de-energize electrical panels and equipment before bundling or securing wiring with cable ties. Insert the cable tie through the tool head, loop around the bundle, and squeeze the handle to tension and cut automatically. Inspect the cut tail to confirm it is flush and does not present a sharp edge hazard in high-contact areas.