Thermwell A62/36H Silver Door Sweep 2x36 Aluminum Neoprene

Product Description

The THERMWELL A62/36H is a silver aluminum door sweep with a triple-seal neoprene rubber bottom designed to block drafts, dust, insects, and moisture at the base of exterior or interior doors. Measuring 2 inches wide by 36 inches long, this sweep features a full-width 2-inch contact surface for thorough sealing across the door bottom. The aluminum body provides rigidity and corrosion resistance, while the triple-seal neoprene rubber flexes against uneven thresholds to maintain a consistent seal. Installation uses screws that pass through both the rubber and the aluminum body, locking the sweep firmly in place without slippage or pull-away over time.

This door sweep is suited for residential and light commercial applications where weatherization and energy efficiency at the door bottom are required. It is commonly installed by HVAC technicians performing building envelope work, general contractors, property maintenance crews, and knowledgeable DIYers. Typical applications include exterior entry doors, garage access doors, and utility room doors where draft control and pest exclusion are priorities.

Key Features

• Full 2-inch-wide sweep surface for maximum contact along the door bottom
• Triple-seal neoprene rubber flexes to conform to uneven thresholds
• Aluminum construction resists corrosion and holds shape under repeated door cycles
• Screw-through design fastens through both rubber and aluminum for a secure, drift-free mount
• Silver finish blends with standard aluminum door and threshold hardware
• 36-inch length fits most standard single-door widths and can be trimmed to size

Compatibility

Designed as an OEM-style replacement and new-install door sweep for standard residential and light commercial door bottoms requiring a 2-inch-wide aluminum sweep with neoprene rubber sealing.

Installation Notes

Installation is typically performed by a general contractor, property maintenance technician, or HVAC service professional during building envelope work. Before installing, confirm the door bottom is clean and free of old sweep adhesive or fasteners. Mark screw positions evenly along the sweep length, then drive screws through the rubber and into the aluminum rail and door face for a secure hold. If trimming the sweep to length, use a hacksaw or tin snips and deburr the cut edge before mounting.