Telemecanique Sensors XZCPV1141L5 M12 Cordset 3A 5m

Product Description

The TELEMECANIQUE SENSORS XZCPV1141L5 is an M12 4-pin female straight cordset designed for connecting sensors and receptacles in industrial control and automation systems. Rated at 3 amps and compatible with up to 250 volts AC or 300 volts DC, this cordset provides a reliable, secure signal and power connection between proximity sensors, photoelectric sensors, and their corresponding controllers. The cable extends 5 meters and carries an IP67 ingress protection rating, meaning it is fully dust-tight and can withstand temporary immersion in water. Licensed electricians and industrial maintenance technicians are the typical installers of this type of cordset.

This cordset is suited for use in light manufacturing, machine tool, material handling, and general factory automation environments where M12 quick-disconnect connections are the standard interface. The straight female connector mates with standard M12 male-threaded sensor bodies and panel-mount receptacles. The 5-meter cable length accommodates typical sensor-to-control-panel runs on machine frames and conveyor systems. The IP67 rating makes it appropriate for washdown-adjacent locations or areas exposed to coolant mist and light moisture.

Key Features

• M12 4-pin female straight connector for secure, tool-free mating with standard sensor bodies
• 3 amp current rating supports both signal and low-power sensor circuits
• Rated for 250 volts AC and 300 volts DC operation
• 5-meter cable length suits most machine-mount to control-cabinet runs
• IP67 ingress protection rating provides full dust exclusion and short-term water immersion resistance

Compatibility

Designed as a standard M12 4-pin female straight cordset for use with industrial proximity sensors, photoelectric sensors, and other devices using the M12 quick-disconnect interface.

Installation Notes

Installation is typically performed by a licensed electrician or qualified industrial maintenance technician. De-energize the circuit and lock out the power source before connecting or disconnecting the cordset. Hand-tighten the M12 coupling nut to the rated engagement stop — do not over-torque, as this can damage the connector body or sealing gasket. Verify the IP67 seal is fully seated and undamaged before returning the circuit to service in any moisture-exposed location.