Telemecanique Sensors XS506B1PBM8 Proximity Sensor M6.5

Product Description

The TELEMECANIQUE SENSORS XS506B1PBM8 is a cylinder shielded inductive proximity sensor designed for non-contact detection of metallic targets in industrial and commercial control applications. Operating on 12 to 24 volts DC, it outputs a PNP normally closed (NC) signal over three wires and connects via an M8 three-pin connector. The sensing head is M6.5 in diameter with an M6x1 thread, and the overall body length is approximately 42 millimeters. It delivers a response frequency of 5,000 Hz, making it well suited for fast-moving target detection. The stainless steel housing carries an IP67 ingress protection rating, providing reliable performance in wet or dusty environments.

This sensor is intended for use in automated machinery, conveyor systems, robotics, and light industrial equipment where precise, high-speed metallic target detection is required. It is well matched to machine control panels, production line equipment, and field installations where vibration and shock resistance are necessary. Licensed electricians and industrial controls technicians are the primary installers. The compact M6.5 head fits into tight mounting locations where space is limited.

Key Features

• 1.5 mm detection distance with 5,000 Hz response frequency for high-speed target sensing
• PNP normally closed (NC) output over three wires with M8 three-pin connector
• 12 to 24 volt DC operating range with up to 200 mA load capacity
• Stainless steel housing rated IP67 for dust-tight and temporary immersion protection
• Shock-resistant and vibration-resistant construction per IEC 60068-2-27 and IEC 60068-2-6
• Operating temperature range of -13 degrees F to 158 degrees F
• CE, CSA, and UL listed; RoHS compliant

Compatibility

Designed as an OEM-style replacement or direct-install inductive proximity sensor for industrial machine control systems requiring an M6.5 cylinder shielded PNP NC sensor with an M8 connector interface.

Installation Notes

Installation should be performed by a licensed electrician or qualified industrial controls technician in accordance with applicable NEC guidelines and local codes. De-energize the control circuit completely before wiring or replacing the sensor. Verify supply voltage is within the 12 to 24 volt DC operating range before powering the circuit. Secure the M6x1 threaded body with the appropriate hardware to prevent loosening under vibration; do not overtighten the housing into the mounting bracket.