Surecall SC-001-10 SC-400 Coaxial Cable 10 Ft N-male

Product Description

The SURECALL SC-001-10 is a 10-foot SC-400 coaxial cable assembly terminated with N-Male connectors on each end, finished in black. SC-400 is a low-loss 50-ohm coaxial cable commonly used in cellular signal booster systems to connect antennas, amplifiers, and splitters. This assembly is sold as a single pre-terminated unit, ready for installation without additional field termination. It is typically installed by low-voltage technicians, telecommunications contractors, or experienced integrators working on in-building cellular coverage systems.

This cable assembly is intended for use in cellular signal booster and distributed antenna system (DAS) installations in residential, light commercial, and small commercial environments. It is suited for routing between an outdoor donor antenna and an amplifier unit, or between an amplifier and indoor coverage antennas. The black jacket suits both indoor and outdoor routing applications where UV and environmental exposure are a consideration.

Key Features

• SC-400 low-loss coaxial construction for minimal signal attenuation over the cable run
• Pre-terminated N-Male connectors eliminate field termination and reduce installation error
• 10-foot length suits short amplifier-to-antenna runs in confined equipment areas
• Black jacket finish for discreet routing in finished or semi-finished spaces
• 50-ohm impedance matches standard cellular booster and DAS component specifications

Compatibility

Designed as an OEM-style cable assembly for use with cellular signal booster systems and DAS components that accept N-Male coaxial connections on SC-400 type cable.

Installation Notes

Installation is typically performed by licensed low-voltage or telecommunications contractors. Ensure all amplifier and antenna ports are unpowered before connecting or disconnecting coaxial assemblies. Avoid sharp bend radii that exceed the cable minimum bend specification, as kinking degrades signal performance. Connections should be hand-tightened and then snugged with the appropriate wrench to ensure a weatherproof interface without over-torquing the N-type connector body.