Sugatsune MN-32 Studded Leveling Mount 3/8-16 Thread

Product Description

The SUGATSUNE MN-32 is a studded leveling mount designed to support and level machinery, equipment enclosures, and fabricated assemblies in industrial and commercial settings. It uses a 3/8-16 threaded steel stud to allow precise height adjustment and carries a rated load capacity of 352 pounds. The polypropylene pad base provides floor protection while distributing load across the contact surface. Licensed millwrights, machine installers, and fabricators install this style of leveling mount during equipment commissioning or repositioning. The compact form factor — with a base diameter of 1-17/64 inches and a height of approximately 1.578 inches — suits tight clearance applications where a low-profile mount is required.

The MN-32 is suited for use under light industrial machinery, control enclosures, workbenches, and fabricated steel frames in both residential and commercial facilities. Its standard 3/8-16 thread size makes it a common fit for equipment that specifies this bolt pattern at leveling foot locations. Install locations typically include factory floors, mechanical rooms, and equipment pads where minor floor irregularities require compensation without full shimming or grouting.

Key Features

• 352 lb rated load capacity per mount
• 3/8-16 threaded steel stud for secure, adjustable engagement
• Polypropylene pad base protects finished and unfinished floor surfaces
• Base diameter of 1-17/64 inches suits compact footprint applications
• Low-profile height of approximately 1.578 inches for tight clearance installs
• Steel stud construction supports firm, vibration-resistant positioning

Compatibility

Designed as an OEM-style leveling mount for equipment and assemblies specifying a 3/8-16 threaded leveling foot location.

Installation Notes

Installation is typically performed by millwrights, equipment installers, or maintenance technicians. De-energize and fully support the equipment before removing or adjusting leveling feet to prevent tip hazard. Use a standard wrench on the steel stud to thread the mount into the equipment base, then adjust height as needed and lock in position per the equipment manufacturer's procedure. Verify that the polypropylene pad sits flat on the floor surface with no rocking before loading the equipment to capacity.