Starrett 16971 Bi-metal Reciprocating Saw Blade 18 Tpi 2 Pack

Product Description

The STARRETT 16971 is a bi-metal reciprocating saw blade designed for cutting metal in a wide range of trade and service applications. At 4 inches in length with an 18 teeth-per-inch (TPI) constant pitch, this blade delivers controlled, clean cuts through metal stock, pipe, conduit, and sheet material. The universal shank fits the vast majority of reciprocating saw models on the market. The straight profile and angled tip allow for easy plunge starts and flush cutting. Each package contains 2 blades. Licensed electricians, plumbers, HVAC technicians, and general contractors are the primary installers of this blade type.

This blade is suited for residential and light commercial cutting tasks where metal removal is required. Typical applications include cutting electrical conduit, copper or steel pipe, threaded rod, metal strapping, and light structural steel during rough-in or retrofit work. The 18 TPI count is best matched to thin-wall tubing and sheet metal up to moderate thickness, where a higher tooth count provides better surface finish and reduced vibration compared to coarser blades. The straight tooth form and constant pitch pattern maintain consistent feed rate through the cut.

Key Features

• Bi-metal construction for extended blade life and resistance to breakage under flex
• 18 TPI constant pitch optimized for clean cuts in thin-wall metal, pipe, and conduit
• 4-inch blade length suitable for pipe, conduit, and light structural cuts
• Universal shank for broad compatibility with standard reciprocating saws
• Angled blade tip supports plunge starting without pre-drilling
• Straight tooth form with toothed cutting edge for consistent metal removal
• Sold as a 2-blade pack

Compatibility

Designed for use with reciprocating saws accepting a universal shank. Intended for metal cutting applications. No specific model compatibility was stated in the product data.

Installation Notes

Blade changes should be performed with the saw unplugged or the battery removed. Ensure the shank is fully seated and the blade clamp is locked before operation. Wear appropriate eye and hand protection when cutting metal, as burrs and chips are generated. Follow applicable safety standards for power tool operation on the job site.