Standard Abrasives 7010310153 Convolute Deburring Wheel

Product Description

The STANDARD ABRASIVES 7010310153 is a silicon carbide convolute deburring wheel designed for surface finishing and edge deburring on metal workpieces. Built to a Density 7 construction, the convolute design delivers consistent cut rate and controlled aggressiveness throughout the life of the wheel. At 6 inches in diameter with a 1/2 inch face width and a 1 inch center hole, this wheel mounts directly to standard arbors on stationary or portable finishing equipment. The fine grade silicon carbide abrasive makes it well suited for light deburring, blending, and surface conditioning on ferrous and non-ferrous metals. Fabricators, machinists, and finishing technicians are the typical end users.

This wheel is intended for use in production finishing environments where consistent, repeatable results are required across high-volume part runs. Its tooling compatibility spans automated equipment, feed-through machines, and straight shaft stationary and portable tools, making it a versatile choice for both inline automated processes and manual bench finishing setups. The fine abrasive grade positions it for finishing operations rather than aggressive stock removal, such as cleaning up stamped parts, removing light burrs from machined components, or conditioning weld areas prior to inspection.

Key Features

• Silicon carbide abrasive — effective on non-ferrous metals, hard alloys, and cast materials
• Density 7 convolute construction provides consistent cut rate as the wheel wears
• Fine grade — suited for light deburring, blending, and surface conditioning
• 1 inch center hole fits standard arbors on a wide range of finishing machines
• Compatible with automated equipment, feed-through machines, and straight shaft tools

Compatibility

Compatible with automated equipment, feed-through machines, and straight shaft stationary and portable tools as stated by the manufacturer.

Installation Notes

Installation is performed by machinists or finishing equipment operators following standard wheel-mounting procedures. Power down and lock out the equipment before mounting or removing the wheel. Verify that the arbor size matches the 1 inch center hole and that the machine spindle speed does not exceed the rated maximum for the wheel. Inspect the wheel for damage before each use and discard any wheel that shows cracking or delamination.