Southwire/coleman Cable 28829022 10/2 Nm-b Wire 50 Ft

Product Description

The SOUTHWIRE/COLEMAN CABLE 28829022 is a 50-foot length of 10/2 non-metallic sheathed cable with ground (NM-B), rated for 90 degrees F conductors. This cable carries two 10 AWG copper current-carrying conductors plus a bare copper ground, all enclosed in a PVC outer jacket. It is a standard residential wiring cable used for branch circuits in dry, protected interior locations. Electricians reach for this gauge when wiring 30-amp circuits such as dryer outlets, water heaters, and large appliance feeds. The 50-foot cut length reduces waste on typical room or panel runs.

This 10/2 NM-B cable is suited for residential and light commercial wiring applications where NEC Article 334 permits non-metallic sheathed cable. Common uses include 30-amp single-phase branch circuits serving dryers, water heaters, HVAC disconnect feeds, and similar loads. The cut length format is practical for service calls and retrofit work where a full coil is unnecessary. Cable is intended for installation in normally dry, indoor locations inside conditioned or unconditioned building cavities, walls, attics, and floor assemblies.

Key Features

• 10 AWG stranded or solid copper conductors rated for 30-amp circuit applications
• 90 degrees F conductor temperature rating for NM-B classification
• Two current-carrying conductors plus bare copper ground in a single jacket
• 50-foot cut length — practical for service work and retrofit installations
• Non-metallic PVC sheath suitable for dry, protected interior locations per NEC 334

Compatibility

Designed as a standard NM-B replacement and new-installation cable for residential 30-amp branch circuits in dry interior locations where non-metallic sheathed cable is permitted by the authority having jurisdiction.

Installation Notes

Installation must be performed by a licensed electrician in accordance with the National Electrical Code (NEC) and all applicable local codes. De-energize the circuit and verify the absence of voltage before terminating conductors. NM-B cable must be protected from physical damage where required by code and is not rated for wet, damp, or direct-burial locations. Secure and support the cable at intervals required by NEC Article 334.