Southwire 19248802 Generator Cord 20A 125/250V 12 Awg

Product Description

The SOUTHWIRE 19248802 is a 4-conductor generator cord rated for 125/250 VAC at 20 amps, built on 12 AWG wire. It provides a reliable power transfer connection between a portable generator and NEMA-style receptacles, making it a practical accessory for temporary power setups on job sites, during outages, or in any application where generator output needs to feed a load safely. The cord handles both legs of a split-phase circuit, allowing balanced 125-volt and 250-volt loads. Electricians and generator service techs keep this cord on hand for fast, code-appropriate hookups without improvising connections.

This cord is intended for use with NEMA receptacles on generators. Typical applications include connecting a portable generator to a transfer switch inlet, powering 240-volt equipment directly from a generator output receptacle, or bridging generator power to a load center during outages. It suits residential and light commercial temporary-power scenarios where a standardized, rated cord is required rather than a field-fabricated assembly.

Key Features

• Rated 20 amps at 125/250 VAC for split-phase generator circuits
• 12 AWG conductors support full 20-amp load capacity without derating concerns
• 4-conductor design carries both hot legs, neutral, and ground
• Compatible with NEMA receptacles found on standard portable generators
• Packaged individually, sold as a single unit

Compatibility

Designed for use with NEMA receptacles on generators. Verify receptacle configuration and amperage rating on your specific generator before connecting.

Installation Notes

Installation should be performed by a licensed electrician or qualified generator service technician following NEC Article 445 and any applicable local codes. Confirm the generator is shut down and the output breaker is in the off position before connecting or disconnecting the cord. Never exceed the rated amperage of the cord or the generator receptacle. Inspect the cord for damage before each use and do not operate in wet conditions unless the connected equipment is rated for wet locations.