Southwark Metal 27R_6X10X7 Sheet Metal Pipe Boot

Product Description

The SOUTHWARK METAL 27R_6X10X7 is a straight sheet metal pipe boot designed to transition from a round duct collar to a rectangular register opening in residential and light commercial HVAC duct systems. Fabricated from hot dip galvanized steel, this boot provides a corrosion-resistant connection point between the supply trunk or branch run and the floor, wall, or ceiling register. The rectangular opening measures 6 inches by 10 inches and the round collar end measures 7 inches in diameter. HVAC sheet metal mechanics and duct installers use this fitting as a standard termination point where supply air is delivered to a conditioned space through a grille or register.

This pipe boot is suited for new construction and replacement duct work in residential forced-air systems and light commercial installations. The straight configuration aligns the round collar directly with the rectangular register face without an offset, making it appropriate for installations where the duct run terminates perpendicular to the register surface. The 6 inch by 10 inch face accepts standard register grilles of that nominal size. It is commonly installed at floor, sidewall, or toe-kick register locations depending on the duct routing layout.

Key Features

• Hot dip galvanized steel construction for corrosion resistance in exposed or semi-exposed duct applications
• Straight configuration transitions 7 inch round collar to 6 inch by 10 inch rectangular register opening
• Conforms to ACCA and SMACNA applicable standards for sheet metal ductwork fabrication
• Compatible with standard 6 inch by 10 inch nominal register grilles
• Register-style boot suitable for floor, sidewall, and toe-kick supply air outlets

Compatibility

Designed as an OEM-style sheet metal fitting for residential and light commercial forced-air supply duct systems terminating at a 6 inch by 10 inch register with a 7 inch round collar connection.

Installation Notes

Installation is typically performed by licensed HVAC technicians or qualified sheet metal mechanics following SMACNA duct construction standards and local mechanical codes. Power down the air handling unit and close the supply shutoffs before cutting into existing ductwork. Secure the boot to the branch duct with sheet metal screws and seal all joints with UL 181-rated mastic or foil tape to prevent air leakage. The register face should be fastened to the finished floor or wall surface per the register manufacturer's instructions.

Technical Specifications

• Material: Hot Dip Galvanized Steel
• Rectangular Opening (Size A): 6 inches x 10 inches
• Round Collar Diameter (Size B): 7 inches
• Type: Register, Straight
• Applicable Standards: ACCA, SMACNA

Standard Information

• Brand: SOUTHWARK METAL
• Manufacturer Part Number: 27R_6X10X7