Southwark Metal 24R_6X14X8 Pipe Boot Elbow 6x14 8in 90D

Product Description

The SOUTHWARK METAL 24R_6X14X8 is a sheet metal pipe boot elbow designed for ducted HVAC distribution systems. This fitting transitions from an 8-inch round duct to a 6-inch by 14-inch rectangular register opening at a 90-degree angle, making it the correct component where round trunk or branch ductwork meets a floor, ceiling, or wall register box. Constructed from hot dip galvanized steel, it delivers corrosion resistance suitable for long-term installation in residential and light commercial air distribution applications. HVAC installers and sheet metal contractors specify this type of fitting when routing supply or return air to a room register location.

This pipe boot elbow is used in forced-air heating and cooling systems where a round branch duct must terminate at a rectangular register. It is suited to residential new construction and retrofit projects where standard 6-inch by 14-inch register openings are specified. The 90-degree elbow configuration allows the duct run to turn directly into the floor or wall cavity without additional fittings. Its galvanized steel construction meets the material requirements common to SMACNA and ACCA duct fabrication standards.

Key Features

• 90-degree elbow geometry transitions 8-inch round duct to a 6-inch by 14-inch rectangular register opening in a single fitting
• Hot dip galvanized steel construction provides corrosion resistance for long-term duct system service
• Fabricated to ACCA and SMACNA applicable standards for duct fittings
• Register-type boot design seats flush against floor, ceiling, or wall surfaces for a clean register installation
• Standard sizing integrates with common 6-inch by 14-inch register grilles and diffusers

Compatibility

Designed as an OEM-style sheet metal fitting for use with standard 8-inch round branch ductwork terminating at 6-inch by 14-inch rectangular register openings in residential and light commercial forced-air HVAC systems.

Installation Notes

Installation should be performed by a licensed HVAC technician or qualified sheet metal contractor in accordance with SMACNA duct construction standards and local mechanical codes. Shut down the air handling unit and confirm the system is de-energized before modifying or connecting ductwork. Seal all joints with listed duct sealant or metal-backed tape per applicable code requirements to prevent air leakage. Do not use sheet metal screws in locations that will obstruct register grille seating or damper operation.

Technical Specifications

• Material: Hot Dip Galvanized Steel
• Size A (Register Opening): 6 inches x 14 inches
• Size B (Round Duct Diameter): 8 inches
• Type: Register, 90 Degree Elbow
• Applicable Standards: ACCA, SMACNA

Standard Information

• Brand: SOUTHWARK METAL
• Manufacturer Part Number: 24R_6X14X8