Southwark Metal 24R_6X12X7 Pipe Boot Elbow 6x12 Register

Product Description

The SOUTHWARK METAL 24R_6X12X7 is a sheet metal pipe boot elbow designed for ducted HVAC distribution systems in residential and light commercial applications. This 90-degree elbow transitions from a 7-inch round duct to a 6-inch by 12-inch rectangular register opening, making it a standard component wherever floor, wall, or ceiling boots connect round trunk or branch duct to a grille or register face. Fabricated from hot-dip galvanized steel, it delivers corrosion resistance appropriate for supply-air ducting. HVAC installers and sheet metal contractors are the primary trades working with this fitting.

This boot elbow is used in forced-air heating and cooling systems where a round branch duct must terminate at a rectangular register. The 90-degree turn allows the duct run to change direction at the point of discharge, a common configuration in floor-to-wall and ceiling installations. The 6-inch by 12-inch register face size is a widely used standard opening that accepts most matching grilles and registers. Construction meets ACCA and SMACNA applicable standards, making it appropriate for code-compliant duct system installations.

Key Features

• 90-degree elbow transitions 7-inch round duct to a 6-inch by 12-inch rectangular register opening
• Hot-dip galvanized steel construction provides corrosion resistance for long-term supply-air service
• Meets ACCA and SMACNA applicable standards for duct fabrication
• Standard register face dimensions accept common grille and register fittings
• Suitable for floor, wall, or ceiling boot applications in forced-air systems

Compatibility

Designed as an OEM-style sheet metal fitting compatible with standard 7-inch round branch duct and 6-inch by 12-inch rectangular grille and register assemblies in residential and light commercial forced-air duct systems.

Installation Notes

Installation is performed by licensed HVAC technicians or qualified sheet metal contractors in accordance with SMACNA duct construction standards and local mechanical codes. Power down the air handling unit and close the fuel supply or disconnect electrical service before working in the duct system. Seal all joints with UL 181-rated mastic or foil tape as required by local code to maintain system efficiency and pressure integrity. Secure the boot to framing or structural members using appropriate sheet metal screws or hangers to prevent movement during operation.

Technical Specifications

• Material: Hot-Dip Galvanized Steel
• Register Face Size (Size A): 6 inches x 12 inches
• Round Duct Diameter (Size B): 7 inches
• Elbow Angle: 90 degrees
• Type: Register Pipe Boot Elbow
• Applicable Standards: ACCA, SMACNA

Standard Information

• Brand: SOUTHWARK METAL
• Manufacturer Part Number: 24R_6X12X7