Southwark Metal 24R_6X10X7 Sheet Metal Pipe Boot Elbow

Product Description

The SOUTHWARK METAL 24R_6X10X7 is a sheet metal pipe boot elbow designed for duct-to-register transitions in residential and light commercial HVAC systems. Built from hot dip galvanized steel, this fitting combines a 6 inch x 10 inch register opening with a 7 inch round collar in a 90-degree elbow configuration. It serves as the terminal connection point where a round duct run meets a floor, wall, or ceiling register boot. HVAC installers and sheet metal contractors use this type of fitting to make the transition from round flex or hard pipe to a rectangular register face cleanly and with a proper seal.

This boot elbow is suited for new construction and replacement installations in forced-air heating and cooling systems. The 90-degree angle makes it appropriate for floor or low-wall register applications where the duct approaches from below or from inside a wall cavity. The 6 inch x 10 inch face fits standard register grilles of that size, while the 7 inch diameter collar connects directly to round duct. Fabricated to ACCA and SMACNA standards, this fitting meets the dimensional and material requirements commonly specified on commercial and residential mechanical drawings.

Key Features

• Hot dip galvanized steel construction for corrosion resistance in exposed or semi-conditioned spaces
• 90-degree elbow geometry suits floor and low-wall register applications
• 6 inch x 10 inch register face fits standard grilles of that size
• 7 inch diameter collar connects to round duct or flex duct with standard clamps or tape
• Fabricated to ACCA and SMACNA applicable standards

Compatibility

Designed as an OEM-style sheet metal fitting for forced-air HVAC duct systems requiring a 90-degree register boot transition from a 7 inch round duct to a 6 inch x 10 inch rectangular register opening.

Installation Notes

Installation is typically performed by a licensed HVAC technician or sheet metal contractor. Shut down the air handler and confirm the system is de-energized before working in the duct system. Seal all joints with UL 181-rated mastic or foil tape per SMACNA guidelines to prevent air leakage at the boot connection. Secure the round collar to the duct with at least two sheet metal screws and an approved draw band or clamp before applying sealant.

Technical Specifications

• Material: Hot Dip Galvanized Steel
• Register Face Size (Size A): 6 inches x 10 inches
• Round Collar Diameter (Size B): 7 inches
• Elbow Angle: 90 degrees
• Type: Register Boot Elbow
• Applicable Standards: ACCA, SMACNA

Standard Information

• Brand: SOUTHWARK METAL
• Manufacturer Part Number: 24R_6X10X7