Smc Pneumatics NCQ-D063 Double Clevis 2.5 in Bore NCQ2

Product Description

The SMC PNEUMATICS NCQ-D063 is a double clevis mounting accessory designed for use with NCQ2 series compact air cylinders. It attaches to the rear of the cylinder body to provide a pivot-pin mounting arrangement, allowing the cylinder to swing through an arc during actuation. This style of mount is commonly used in pneumatic automation systems where the load path shifts angle during the stroke. The NCQ-D063 is sized for a 2.5-inch bore cylinder. Installation is performed by millwrights, maintenance technicians, and automation system integrators working on pneumatic circuit assemblies.

The NCQ-D063 double clevis is intended for use with SMC NCQ2 series compact cylinders in industrial and light commercial pneumatic applications. Typical installation scenarios include factory automation fixtures, pneumatic clamping systems, and actuator assemblies where angular misalignment or pivoting motion must be accommodated at the cylinder mount point. The accessory ships as a single unit and is matched to the 2.5-inch bore NCQ2 cylinder family.

Key Features

• Double clevis design allows pivot-pin mounting for swing-arc cylinder travel
• Sized specifically for 2.5-inch bore NCQ2 series compact air cylinders
• OEM-matched accessory for consistent fitment and alignment
• Single-unit packaging suitable for direct replacement or new assembly

Compatibility

Designed for use with SMC NCQ2 series compact air cylinders with a 2.5-inch bore.

Installation Notes

Installation is performed by qualified pneumatic system technicians or maintenance personnel. Before mounting or removing any cylinder accessory, depressurize the pneumatic circuit completely and verify that the system is locked out and tagged out per site safety procedures. Secure the clevis pin with the appropriate retaining hardware and verify that all pivot points move freely without binding before returning the system to service. Consult the cylinder manufacturer documentation for torque and alignment requirements applicable to the specific assembly.