Sk 40914 Hand Socket 7/16 Inch 6-point 1/4 Inch Drive

Product Description

The SK 40914 is a 7/16 inch, 6-point hand socket designed for use with 1/4 inch drive ratchets and extensions. Constructed from steel with a chrome finish, this standard-length socket provides solid engagement on hex fasteners while resisting corrosion and wear in demanding shop and field environments. The 6-point design contacts fastener flats rather than corners, reducing the risk of rounding under load. At 0.05 pounds, it is lightweight enough for overhead or confined-space work without sacrificing durability. It is appropriate for HVAC technicians, plumbers, electricians, and general trade professionals who need reliable hand tool access to 7/16 inch fasteners.

This socket sees regular use in mechanical and electrical service work where 1/4 inch drive tools are standard — including control panel access, equipment mounting hardware, and fixture installation. The standard length suits most flush and recessed fastener applications without requiring an extension. It is a practical addition to any service technician's socket set when working around tight clearances common in residential and light commercial mechanical systems.

Key Features

• 7/16 inch socket size for common fastener sizes found in HVAC, electrical, and plumbing applications
• 6-point geometry contacts fastener flats to reduce fastener rounding under torque
• 1/4 inch drive compatibility works with standard ratchets, extensions, and T-handles
• Chrome-plated steel construction resists corrosion and surface wear
• Standard length fits most typical fastener access scenarios without additional extension
• Limited lifetime warranty from the manufacturer

Compatibility

Designed for use with any 1/4 inch drive ratchet, extension, or speed handle following standard drive tool conventions.

Installation Notes

Install and remove using a 1/4 inch drive ratchet or extension bar. Ensure the socket is fully seated on the fastener before applying torque to avoid slippage or fastener damage. Inspect the socket and drive square for wear before use, and replace any socket showing cracks, chips, or a loose drive fit. No power lockout is required for hand tool use, but follow all applicable site safety procedures when working on energized or pressurized systems.