Siemon Company 9C6P4-E3-02-RXA CAT6 Utp Patch Cable

Product Description

The SIEMON COMPANY 9C6P4-E3-02-RXA is a Category 6 unshielded twisted pair (UTP) patch cable rated at 250 MHz and designed for structured cabling installations in commercial and residential network environments. Built with a 4-pair configuration and a CMR (Communications Multipurpose Cable, Riser) jacket rating, this 1-meter cable supports high-speed data transmission between network equipment, patch panels, and horizontal cabling termination points. The white jacket finish aids in cable management and color-coding schemes. Licensed network cabling technicians and low-voltage installers are the primary trades that work with this product.

This cable is suited for horizontal or riser pathway installations where a short, compliant Category 6 run is needed. Typical applications include patch panel-to-switch connections in telecommunications rooms, equipment room inter-device links, and short structured cabling segments within a rack or cabinet assembly. The CMR jacket rating makes it appropriate for use in riser pathways between floors, in compliance with NEC Article 800 riser cable requirements. At 1 meter in length, it is most commonly used as a short equipment or patch bay connection.

Key Features

• Category 6 UTP construction supporting bandwidth up to 250 MHz
• 4-pair unshielded twisted pair design for standard structured cabling applications
• CMR (riser) jacket rating for use in vertical shaft and riser pathway installations per NEC Article 800
• 1-meter length suited for short patch bay, rack, and equipment room connections
• White jacket color for easy identification and color-coded cable management
• Sold as a single unit (EA) for targeted replacement or small-quantity installs

Compatibility

Designed as a standard Category 6 UTP patch cable compatible with Category 6 and Category 5e keystone jacks, patch panels, and RJ45 ports in structured cabling systems meeting TIA-568 Category 6 specifications.

Installation Notes

Installation should be performed by a qualified low-voltage cabling technician familiar with TIA-568 structured cabling standards and NEC Article 800 requirements for communications cables. Before terminating or replacing cables in an active rack, power down or disconnect the relevant network ports to avoid ESD damage to active equipment. Avoid sharp bends below the cable minimum bend radius and do not exceed the cable maximum pulling tension during installation. CMR-rated cables are not approved as a substitute for CMP (plenum) cables in air-handling plenum spaces.