Sharkbite U280LFA 1/2 Inch Mip Push Fit Elbow Lead Free 6 Pack

Product Description

The SHARKBITE U280LFA is a 1/2-inch x 1/2-inch male iron pipe (MIP) push-fit elbow designed for fast, tool-free connections in potable and hydronic water distribution systems. Constructed from lead-free DZR brass, this fitting is rated to 200 psi and 200 degrees F, making it suitable for both domestic water supply and hydronic heating applications. An integral tube liner is included, ensuring a secure push-fit engagement without additional prep tools. Licensed plumbers and journeymen installers use this fitting where a 90-degree direction change is needed at a threaded male iron pipe connection.

This elbow is compatible with copper tubing, CPVC, and PEX pipe in residential and light commercial plumbing systems. It is certified for underground applications as a manufactured joint, eliminating the need for an access panel after installation. The push-fit design reduces labor time significantly compared to soldered or threaded alternatives, making it a practical choice for tight spaces, repair work, and new construction rough-in alike. Each package contains 6 fittings.

Key Features

• Push-fit connection — no solder, clamps, or crimping tools required
• Rated to 200 psi and 200 degrees F for demanding water distribution service
• Lead-free DZR brass construction meets Federal Law 111-380 lead-free compliance requirements
• Integral tube liner included for use with copper, CPVC, and PEX tubing
• Certified for underground applications as a manufactured joint without access panel requirement
• Design certified to ASSE 1061 and NSF 61 standards; meets UPC, IPC, and CUPC requirements; listed with IAPMO

Compatibility

Compatible with copper tubing (copper tube size), CPVC, and PEX pipe at 1/2-inch connections. Certified for use on potable and hydronic water distribution systems.

Installation Notes

Installation should be performed by a licensed plumber in accordance with local plumbing codes referencing the IPC or UPC. Shut off the water supply and relieve system pressure before installing or removing any push-fit fitting. Ensure pipe ends are cut cleanly and squarely and are free of burrs or debris before insertion; the integral tube liner must be properly seated when working with PEX or CPVC. To disconnect a SharkBite push-fit fitting, use the manufacturer-recommended disconnect clip or tool — do not attempt to pull the fitting free while the system is under pressure.

WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.