Sharkbite/cash Acme 23050 Pex Bend Support 3/8 1/2 Inch 12pk

Product Description

The SHARKBITE/CASH ACME 23050 is a plastic PEX terminal bend support designed to guide PEX tubing through smooth, clean directional transitions at walls and manifolds. Sold in a pack of 12, these elbow-style supports attach to compatible galvanized PEX brackets and accommodate both 3/8 inch and 1/2 inch PEX tubing sizes. The plastic construction keeps the tubing bend radius consistent, reducing kinking risk at entry and exit points. Plumbers and PEX installers use these supports during rough-in and finish work where tubing must change direction cleanly without stressing the pipe wall.

These bend supports are suited for residential and light commercial plumbing applications where PEX tubing runs through framed walls, floors, or manifold installations. They are designed to attach to straight galvanized PEX brackets and angle galvanized PEX brackets, providing controlled transitions up to and out of wall assemblies or manifold banks. The dual-size compatibility for 3/8 inch and 1/2 inch tubing makes them useful across a range of domestic water distribution layouts.

Key Features

• Fits both 3/8 inch and 1/2 inch PEX tubing in a single support design
• Plastic elbow construction guides tubing through smooth directional bends without kinking
• Attaches to compatible straight and angle galvanized PEX brackets for secure mounting
• Facilitates clean transitions at walls and manifolds during PEX rough-in work
• Sold in a pack of 12 for multi-run or multi-zone installations

Compatibility

Designed to attach to straight galvanized PEX brackets and angle galvanized PEX brackets for use with 3/8 inch and 1/2 inch PEX tubing systems in residential and light commercial plumbing installations.

Installation Notes

Installation is performed by licensed plumbers or qualified PEX installers following local plumbing codes and IPC guidelines. Shut off the water supply and depressurize the lines before working on any PEX distribution system. Snap or clip the bend support onto the appropriate bracket type before routing the PEX tubing through the support to maintain the correct bend radius. Do not force tubing through the support at angles that exceed the support geometry, as this can stress the fitting connection point.