Sharkbite 24687 Push-to-connect Faucet Connector 1/2x1/2x30

Product Description

The SHARKBITE 24687 is a 1/2-inch x 1/2-inch x 30-inch Click Seal Push-To-Connect Straight Stop Faucet Connector designed for potable water supply and hydronic heating applications where an in-line shutoff is required. The push-to-connect end accepts copper, CPVC, or PEX pipe without soldering, clamps, unions, or glue — stainless steel teeth grip the pipe on insertion while a specially formulated O-ring compresses to form a pressure-tight seal. The Click Seal nut on the faucet-supply end is hand-tightened until it audibly clicks, confirming a secure connection. Licensed plumbers and experienced DIYers install this valve where a shutoff at the faucet supply stub-out is needed.

This connector is suited for residential and light commercial faucet installations, including kitchen and lavatory faucets, where the supply stub-out is 1/2-inch pipe and the faucet inlet requires a 1/2-inch connection on a 30-inch flexible supply line. The push-to-connect inlet is compatible with copper, CPVC, and PEX pipe in any combination, making it practical for retrofit work without the need to match pipe material. It is certified for potable water supply and hydronic heating service.

Key Features

• Click Seal nut provides a tool-free, audible-confirmation seal on the faucet-supply end
• Push-to-connect inlet grips copper, CPVC, or PEX pipe — no solder, glue, or clamps required
• Stainless steel teeth and compression O-ring create a leak-resistant, pressure-rated seal
• Integrated straight stop shutoff allows water to be isolated at the fixture without shutting off the branch line
• Fitting can be rotated after assembly for easier routing in confined spaces
• Disassembly is possible using a standard SharkBite disconnect clip, allowing the fitting to be removed and reused

Compatibility

Certified for potable water supply and hydronic heating applications. Compatible with copper, CPVC, and PEX pipe on the push-to-connect inlet end. Designed as a straight stop faucet connector for 1/2-inch supply lines with a 30-inch overall length.

Installation Notes

Installation is typically performed by a licensed plumber or qualified tradesperson. Shut off the water supply and relieve line pressure before connecting or disconnecting the fitting. Pipe ends must be cut square, deburred, and cleaned before insertion to the depth mark to ensure the stainless steel teeth seat properly. Consult applicable local plumbing codes and IPC guidelines for approved use of push-to-connect fittings in your jurisdiction.